Watchguard WGSENTINEL Bedienungsanleitung PDF herunterladen (Seite 5)

1.2. The Passive Infrared Detector (PIR)

The detector is a high quality infrared body movement detector, which is

battery operated and communicates with the Watchguard Sentinel Home

Alarm System via radio frequency (RF) transmission. This detector is easy to

install, provides excellent detection sensitivity and has a long battery life (up to

3 years). This detector transmits an alarm code to the unit when a valid

movement is detected.

IMPORTANT NOTES

• NEVER touch the pyro detector with your fingers

• During the warm up period, (first 3 minutes after installing the batteries)

the detector will not respond to movement in front of the detector. You

must wait 3 minutes before it will respond properly.

The wire, which runs around the edge of the detector, is the antenna. Do not

touch, remove or cut this wire

1.3 The Strobe and Siren

The siren/strobe contains the main alarm unit for the Watchguard Sentinel

Home Alarm System.

Functions:

The LED

• The LED will stay on when the unit is in learn mode

• When the unit is disarmed, the LED will flash continuously at a slower

rate (Eg: One flash every two seconds)

• When the unit is armed, the LED will flash continuously at a faster rate

(Eg: One flash per second)

• When the “Exit Delay” function is active, the LED will stay on

continuously for a 20 second period.

The Strobe:

• When the system is armed, the strobe will flash twice

• When the system is disarmed, the strobe will flash three times

• If the alarm is triggered, the strobe will flash continuously until the unit is

disarmed.

1 2 3 4 5 6 7 8 9 10 ... 24 25

Keine Kommentare

Watchguard WGSENTINEL Bedienungsanleitung Seite 5